Turning On The Freewave Ir Commander - Vello FWIRC-N User Manual

TURNING ON THE FREEWAVE IR COMMANDER

To turn on the FreeWave IR
Commander, slide the power
switch to the On position. When
turning off the Commander, it will
remember all your current settings.
Once mounted on your camera, you
can rotate the Commander for line-
of-sight positioning. The Commander's
transmitter should be facing the flash's
IR sensor, and there should be no
obstructions between the two units.
12
Test Button/Ready Light
The ready light indicates the status
of the Commander. When it glows
red, the Commander is ready to
be fired. When the light is off,
the Commander is recycling.
To fire a test flash, press
the Test [ ] button.
Tip: After changing any settings in your
wireless setup, press the test button to fire
a test flash and confirm your new settings.
The slave flashes will fire at a nominal
power setting for firing confirmation.