Vello FWIRC-N User Manual page 24

To set the FreeWave IR Commander to
stroboscopic mode, follow these steps:
1. Mount the Commander on your
camera.
2. Press the Mode button to enter
stroboscopic mode.
3. Press the Set button repeatedly until
the desired group indicator blinks,
and press the Mode to enable or
disable the group.
24
4. Press the Set button repeatedly until
the flash output level blinks, and use
the Left and Right [
buttons to adjust the output from
1/128 to 1/4.
5. Press the Set button to make the
stroboscopic frequency number
blink, and use the Left and Right
[ ] navigation buttons to adjust the
frequency from 1 to 100.
6. Press the Set button to make the
flash count number blink, and use
the Left and Right [
buttons to adjust the count from
1 to 24.
] navigation
Flash Output
] navigation
Frequency Flash Count