Table of Contents
Advertisement
Adjusting a Flash Group's
TTL Power (EV)
Flash output compensation (EV) can be
set in i-TTL and AA modes (for more
information about i-TTL, refer to i-TTL
Mode on page 16). EV is displayed in
decimal form and can be adjusted from
-3.0 to +3.0 in 1/3-stop increments.
EV is set individually for each group.
To adjust EV:
1. Make sure the desired group is in
AA mode.
2. Press the Set button repeatedly until
the desired EV number blinks, and use
the Left and Right [
buttons to adjust the EV.
] navigation
EV
19
Advertisement
Table of Contents
