Table of Contents
Advertisement
• Make sure that the Commander is
within the transmission range and
the wireless sensor on the slave is
pointing toward the Commander.
Remove any obstructions in the line
of sight between the two.
• Ambient light may affect IR
transmission
• Make sure that the electrical contacts
on the foot of the slave unit are not
dirty. Clean them and try again.
• Change the channel on both the
Commander and the slave flash units.
Make sure all units are set to the
same channel.
Note: After changing any settings in your
wireless setup, press the test button to fire
a test flash and confirm your new settings.
29
Advertisement
Table of Contents
