Hole Punch; Fold - Xerox WorkCentre 75xx Series Reference Manual

Hole Punch

This command indicates hole punches for a print job on a device with hole punch capability.
PJL COMMENT Cmd
@PJL COMMENT
OID_ATT_PUNCH int;
Where int is:
0 = Punch Off
1 = Punch On
2 = Use 2 Hole Punch
3 = Use 3 Hole Punch
4 = Use 4 Hole Punch
Note: int 1 will be emitted to invoke the default punch
setting on the device.
Note: Setting NumHoles to 1 causes a punch with the
default number of holes.

Fold

This command indicates an optional fold type generated by the professional finisher. The short edge feed command is
also required to use the booklet fold command.
PJL COMMENT Cmd
@PJL COMMENT
OID_ATT_FOLD string;
Where string is:
TRIFOLDC
TRIFOLDZ
ZFOLD
Note:

TriFold C requires a LeadingEdge 0 and/or OID_VAL_FEED_EDGE_SHORT_LEADING command to
insure SEF feeding.

TriFold Z requires a LeadingEdge 0 and/or OID_VAL_FEED_EDGE_SHORT_LEADING command.
dc10cc0470
Customer Support
DSC Comment Cmd
%%OID_ATT_PUNCH int;
DSC Comment Cmd
%%OID_ATT_FOLD
OID_VAL_FOLD_string;
PS Cmd
<</Punch int1 /PunchDetails <</Type 6 /NumHoles
int2 >>>>
Where int1 is:
0 for Punch Off
4 for Punch On after each showpage or copy page
operation.
Where int2 is:
0 = Punch Off
1 = Punch On
2 = 2 Hole Punch
3 = 3 Hole Punch
4 = 4 Hole Punch
Note: Setting NumHoles to 1 causes a punch with the
default number of holes.
PS Set Page
/Fold int1
/FoldDetails /Type 5 /FoldMethod int2
Where int1 is:
0 = No Fold
3 = Fold at end of set
Where int2 is:
1 = TriFold C
2 = TriFold Z
3 = Z-Fold HalfSheet
Page 17