Table of Contents
Advertisement
Cover
• Tilt the machine head ( p. 10)
• Throat plate ( p. 14)
• Feed dog ( p. 15)
Fig. 32: Setting the loop stroke position (2)
(1) - Threaded pins
(2) - Hook tip
To set the loop stroke position:
1. Lock the machine in place at position 1 ( p. 16).
2. Position the upper stitch length adjusting wheel to 0.
3. Loosen the threaded pins (1).
4. Turn the hook such that the hook tip (2) points exactly to the vertical
5. Tighten the threaded pins (1).
6. Remove the lock.
Order
Then check the following settings:
• Timing of cutting by the thread cutter ( p. 65)
50
①
center line of the groove (3).
Position of the hook and needle
(3) - Needle groove
Service Instructions 667 - 00.0 - 04/2016
③
②
Advertisement
Table of Contents
