Aligning The Needle Bar Linkage; Moving The Needle Bar Linkage Sideways - DURKOPP ADLER M-TYPE 667 Service Instructions Manual

Aligning the needle bar linkage

9
Order
First, check the following setting:
• A straight and undamaged needle must be inserted
Proper setting
Position the upper and lower stitch length adjusting wheel to 0.
 The needle pierces exactly in the center of the feed dog needle hole.

9.1 Moving the needle bar linkage sideways

Cover
• Arm cover ( p. 11)
• Head cover ( p. 12)
Fig. 27: Moving the needle bar linkage sideways (1)
(1) - Threaded pins
(2) - Adjusting rings
To move the needle bar linkage sideways:
1. Set the upper and lower stitch length adjusting wheel to 0.
2. Loosen the threaded pins (1) on the two adjusting rings (2) at the right-
Service Instructions 667 - 00.0 - 04/2016
Aligning the needle bar linkage
( Operating Instructions, chap. Inserting and replacing the needle)
WARNING
Risk of injury from moving parts!
Crushing possible.
Switch off the machine before aligning the needle
bar linkage sideways.
hand end of the shaft for the needle bar linkage.
(3) - Throat plate
(4) - Needle bar linkage
43