Table of Contents
Advertisement
Fig. 37: Setting the stroke movement for the feeding foot (2)
Proper setting
The feeding foot reaches the level of the throat plate at the same time as
the following elements:
To set the stroke movement for the feeding foot:
1. Screw in the threaded pin (3) so that there is a stroke.
2. Loosen the threaded pins (2).
3. Turn the stroke eccentric (1) such that the feeding foot reaches the
Important
When doing so, ensure not to move the stroke eccentric (1) laterally on the
axle.
4. Tighten the threaded pins (2).
5. Unscrew the threaded pin (3) far enough so that there is no longer any
56
(1) - Stroke eccentric
(2) - Threaded pins
• The feed dog moving up
• The needle tip moving down
level of the throat plate at the same time as the feed dog and the tip
of the needle.
contact with the clamp.
(3) - Threaded pin
Service Instructions 667 - 00.0 - 04/2016
Sewing feet
Advertisement
Table of Contents
