Table of Contents
Advertisement
5. Press the OK button (5).
Fig. 54: Setting the potentiometer (2)
6. Check whether the lifting gear plates are flush.
7. Loosen the threaded pins (1).
8. Set the connecting clamp (2) for the lifting cylinder such that the plates
9. Tighten the threaded pins (1).
10. Loosen the threaded pin (3).
11. Turn the potentiometer axle such that the left display shows 1 in the
12. Tighten the threaded pin (3) without changing the value shown in the
13. Press the ESC button two times.
Important
14. Switch off the machine at the main switch.
15. Switch on the machine at the main switch.
Switching off and on will save the setting.
72
(1) - Threaded pins
(2) - Connecting clamp for lifting cylinder
If the plates are not flush:
are flush.
first instance and the relevant maximum speed next to it.
display.
Setting the potentiometer
(3) - Threaded pin for the setting shaft
(4) - Potentiometer
Service Instructions 667 - 00.0 - 04/2016
Advertisement
Table of Contents
