Table of Contents
Advertisement
WI1092E 10/05
ZON E O PTI ONS / ZONE S 1- 9 6 (AD DRESS 12 0 0-2 3 86 )
ZONE OPTIONS: Select zone options for any zone.
1.
Select the desired zone option by entering the option number (1-8) for each selected zone.
2.
Enter corresponding option number in address location, in Binary (Bit) Format.
NOTE: Dark shaded data value box shows option not available. Press
NOTE: See Direct Address Programming Example on page 15.
NOTES:
(A) 50ms & 20 ms Loop Response only available for zones 1-8.
(B) 2-wire Smoke Detectors only available for zones 1-8. Refer to Installation Instructions (WI1093) for more details.
If 2-wire Smoke Detectors are selected, then Fire must also be selected.
(C) If Fire Alarm Verification is selected, then Fire must also be selected.
DEFAULTS: The zone options indicated are automatically set after exiting the Easy Menu Driven Mode.
Priority, Selective Bypass, Alarm Output, Auto Reset, Swinger Shutdown , Zone Area 1 and Zone Area 2 are enabled for
the total number of zones entered in
Alarm Telco 1 is enabled for the zones if [YES] is entered for "REPORT ALL ZONES TO CENTRAL ZONES? Y/N".
Entry/Exit 1 and Chime are enabled for zone numbers entered in
Exit/Entry Follower and Interior Bypass are enabled for zone numbers entered in
Fire, Pulse Alarm Output and Fire Verification is enabled for the zone numbers entered in
2-Wire Smoke Detector is enabled for zone numbers entered in
Note: See "Number of Zones
& Keypads per Area" in Easy
Menu Driven program Mode.
L
NAPCO Security Systems
"AREA 1 # ZONES = 08" and "AREA 2 # ZONES = 00"
"EXIT / ENTRY ZONES"
"2 WIRE FIRE ZONES"
U
D
or
to save
.
.
.
"INTERIOR ZONES"
.
"FIRE ZONES"
.
X
GEM-X255 Programming Instructions
Page 37
Advertisement
Table of Contents
