Table of Contents
Advertisement
WI1092E 10/05
SYST EM RES ET OPT ION S (ADDR ESS 4091-4093)
4091 XX
GEM-RP1CAe2/GEM-K1CA Keypad
GEM-RP2ASe2 Keypad
4091XX
4093 XX
GEM-RP1CAe2/GEM-K1CA Keypad
GEM-RP2ASe2 Keypad
4093XX
NOTE: Some features (schedules, language configuration) can only be re-programmed with the Downloading Software.
USER PROGRAM MODE
PRELIMINARY INFORMATION
The User Program Mode is covered in detail in the operating instructions for the keypad in use.
Only Keypad #1 may be used for programming, however this keypad may be located in any area.
The Program Mode cannot be accessed while the communicator is transmitting except during the first three minutes after power-
up.
After entering codes or data, press the save
If the keypad is in the Program Mode and no activity is detected for longer than 4 minutes, a steady tone will sound.
NOTE: For ease of programming, it is recommended that a GEM K1CA (or GEM-RP1CAe2) be used as Keypad #1. A new GEM-
K1CA and a new GEM-RP1CAe2 are automatically configured as Keypad #1. See Keypad Configuration Mode.
Press the
C
button to silence the sounder and exit the User Program Mode.
L
NAPCO Security Systems
Clear Dealer Program (Erases Dealer Program)
This erases the dealer program. Use this feature to start a
customized default program.
Access address 4091, then press the
allowed.
NOTE: Enter Easy Menu Driven Program Mode to program system again.
Cold Start (Erases Entire Program)
This erases the entire program (codes, schedules, foreign
language configuration, etc), leaving the panel as it came
right out of the box.
Access address 4093, then press the
allowed.
U
button. Data will not be stored into memory unless this button is pressed.
J
U
or
button. Data entry is not
J
U
or
button. Data entry is not
X
GEM-X255 Programming Instructions
Page 57
Advertisement
Table of Contents
