Adding A Nic - HP IBRIX X9720 Administrator's Manual

Adding a NIC

On the Add NIC dialog box:
1. Complete the following fields as needed:
NOTE:
Name: To configure an active physical network, enter the name of the existing physical
interface, such as eth4 or bond1). To configure a virtual interface (VIF), enter a name
based on the existing physical network, such as bond0:1.
Net Mask: Enter the net mask for the subnet. The default is 255.255.255.0.
Route: Each network interface has an entry in the system routing table for handling traffic.
If you enter a new route (IP address) for the interface, it overwrites any current entry for
this interface.
MTU: Maximum Transfer Unit for Ethernet. Leave blank to use the standard MTU value.
2. Click OK when finished.
Name and IP Address are required fields.
Configuring High Availability on the cluster 45