Raid Configuration - NEC MH4500 User Manual

RAID Configuration

Two of the options available for your system are the Mylex AcceleRAID 250
(SecuRAID 210) or the Mylex AcceleRAID 1100 (SecuRAID 530) Controller
board. These boards give your system the added security of fault tolerance. If
you order a system with the RAID controller, the system is pre-cabled at the
factory.
If you are adding the Mylex AcceleRAID Controller board to an existing
system, you must install and configure the controller. You do not have to change
any cabling in your system. Your system board recognizes the installation of the
RAID controller. Refer to Chapter 4, "Upgrading Your System" for procedures
to install an option board. Refer to Chapter 3, "Configuring Your System" for
more information on the Mylex AcceleRAID Controller board
Note: Next Boot Status for the Symbios SYM53C896
controller must be turned OFF if you install the optional
Mylex AcceleRAID Controller board in your system. See
"Symbios Configuration Utility" in Chapter 3 of this guide for
information.
Note: Ensure a jumper is installed on JP10 of the Mylex
AcceleRAID Controller board. Refer to the Mylex
AcceleRAID Installation Guide for the location of jumper
JP10.
System Cabling A-5