Pci Configuration Submenus - NEC MH4500 User Manual

Feature
Use Multiprocessor
Specification
Large Disk Access
Mode
System Wakeup
Feature
Pause Before Boot
Advanced Chipset
Control

PCI Configuration Submenus

The following tables show the settings for the PCI Device Embedded SCSI
submenu and PCI Devices submenu. The submenus should only be changed by
qualified technical personnel.
Leave the PCI Device Embedded SCSI submenu at factory-
default settings. This submenu should only be changed by
qualified technical personnel.
Feature
Option ROM Scan
Enable Master
Latency Timer
Active Termination
Advanced Menu
Choices Description
1.1 Selects version of multiprocessor
1.4 specification to use. Some
operating systems require version
1.1 for compatibility reasons.
LBA Select LBA for IDE drives.
CHS
Disabled If enabled, the system powers up
Enabled upon receiving a "magic packet" on
LAN, ring on COM2, or PME
interrupt from a PCI board.
Enabled Enables five second delay before
Disabled booting operating system.
Press Enter Refer to "Advanced Chipset Control
Submenu."
! CAUTION
PCI Device, Embedded SCSI Submenu
Choices Description
Enabled Enables option ROM scan of the
Disabled selected device. Used to enable
embedded Symbios SCSI
controller
Enabled Enabled selects the device as a
Disabled
PCI bus master.
Default Minimum guaranteed time, in units
0020h of PCI bus clocks, that a device
0040h may be master on a PCI bus.
0060h Caution: Do not change this setting
0080h unless you fully understand the
00A0h priority of this device on the PCI
00C0h bus.
00E0h
Disabled Selects the setting of the onboard
SCSI A On
Your Setting
Your Setting
Configuring Your System 3-7