Table of Contents
Advertisement
adding disks to Slot3 of Group1 and Group2 by using ftdiskadm:
(Example)
After selecting "y", RAID configuration starts, and unless there is any problem, the process
completes. The status of RAID can be viewed by the above "Raid Status".
*1 Before entering the slot number, make sure the disk and the other disk of the pair are inserted to
the SCSI slots.
*2 When necessary, enter a disk label. When the disk is to be used as a single partition, the disk
label will be used as entered here. If the disk is to be divided to multiple partitions, "entered
value_s<partition number>" will be used. However, disk labels may be changed by using
commands including e2label.
*3 Enter a number of partitions to divide the disk. Then enter the size in MB for each partition. For
the last partition, the remaining value will be assigned automatically. The partition number
begins with 1 and the next number will be 5 and the rest will be in ascending order. A certain
size of partition is reserved for the last partition. Thus the range of specifiable value is smaller
than the actual disk capacity. In addition, the actual partition size changes little depending on the
disk structure.
8-11
Advertisement
Table of Contents
