NEC Express 5800/320Lb-R User Manual page 189

Connect from the Management PC Directly Linked (through Serial port B)
On the management PC that is linked directly to Serial port B of the main unit, perform the steps
below:
Start the management PC where MWA is installed. From the Start menu, select [Program]
112.
→ [NEC MWA] → [MWA].
When MWA starts, the initial screen "Remote Control Manager" will appear.
Select [Environment] – [Direct Connection Setting] from the [File] menu of NEC MWA
113.
to display the [Direct Connection] dialog box. Configure the following settings:
<Direct Connection>
Port No.: COM port on the management PC to be connected
Baud Rate: 19200
Flow Control: None
From MWA's [File] menu, select [Configuration] command to open [Configuration]
114.
dialog box.
Select [New] to display [Select a model] dialog box.
115.
Check [Write to FD] and select an applicable model to open [Configuration for ft Series]
116.
dialog box.
Ex) The model name is printed on the front cover like "NEC Express5800/320Lb,"
or "NEC Express5800/320Lb-R."
[Configuration for ft Series] dialog box, specify/register configuration information
117.
including the names of computers to be managed, and then write the information to FD as
the following filename:
<Filename>
CSL_LESS.CFG
Right-clicking the server name to open the pop-up menu and select [Property] command
118.
to open [Property] dialog box.
When [Property] dialog box appears: specify the items as follows:
119.
<[ID] page>
Connection mode:
COM:
Right-clicking the server name to open the pop-up menu and select [Open Remote
120.
Console] to open [MWA Remote Console].
After checking to see if the server window is open on [MWA Remote Console], click the
[Connect] button.
Hook up the management PC directly to Serial port B of the computer to be managed.
121.
Insert NEC EXPRESSBUILDER CD-ROM into the drive of the managed computer and
122.
insert the floppy disk storing the configuration information (CSL_LESS.CFG) into the
FDD drive.
COM
Direct (cross cable)
5-61