Table of Contents
Advertisement
4-34
SCSI Bus Settings
If you put the cursor on "SCSI Bus Settings" with keyboard cursors (↓ and ↑) in the "Configuration
Settings" menu and press Enter, the screen for setting the information on the SCSI bus of the host
adapter appears.
The table below shows the parameters of the setting items and their factory settings.
The settings can be made for each SCSI bus.
IMPORTANT:
Submenu item
Parameter
SCSI Bus0
SCSI Bus SCSI ID
0, 1, 2, 3, 4, 5, 6,
[7], 8, 9, 10, 11,
12, 13, 14, 15
SCSI Bus Reset
[Enabled]
Disabled
SCSI Bus Reset
0, 1, 2, 3, 4, [5],
Delay
6, 7, 8, 9, 10, 11,
12, 13, 14, 15
SCSI Bus
Auto
Termination
High only
Disabled
[Enabled]
Autoconfigure SCSI Device
If you put the cursor on "Autoconfigure SCSI Device" with keyboard cursors (↓ and ↑) in the
"Configuration Settings" menu and press Enter, the screen for setting the information on the device
connected to the host adapter appears.
The parameters of the setting items and their factory settings are the same as those shown in the
table for "SCSI Device Settings."
IMPORTANT:
The settings can be made for each SCSI bus and SCSI ID. Check the SCSI ID of the target
device before changing the settings.
The factory settings are the same for both SCSI bus 0 and SCSI bus 1.
The following items can be changed by setting "Adapter Configuration" in "Autoconfigure
SCSI Device" to "Manual."
– Enable Device
– Enable LUNs
– Negotiate Wide
– Negotiate Sync
– Tagged Queuing
– Sync Offset
– Sync Period
– Exec Throttle
Description
SCSI Bus1
0, 1, 2, 3, 4, 5, 6,
Select the SCSI ID given to SCSI
[7], 8, 9, 10, 11,
bus.
12, 13, 14, 15
[Enabled]
Make the reset valid or invalid in
SCSI buses.
Disabled
0, 1, 2, 3, 4, [5],
Leave this item as factory-set.
6, 7, 8, 9, 10, 11,
12, 13, 14, 15
[Auto]
Set the termination resistance of
SCSI bus.
High only
Disabled
Enabled
[ ]: Factory-set
Advertisement
Table of Contents
