Table of Contents
Advertisement
4-40
Pins for protecting/clearing the passwords
Place the clip on the two pins to clear the passwords.
Remove the clip from these pins to protect the passwords (factory-set).
Pins for protecting/clearing the CMOS data
Place the clip on the two pins to clear the CMOS data.
Remove the clip from these pins to protect the CMOS data (factory-set).
The following describe the clearing procedure.
Observe the following instructions to use the server safely. There are risks of
death or serious personal injury. See PRECAUTIONS FOR SAFETY in Chapter
1.
Do not disassemble, repair, or alter the server.
How to Clear CMOS
Power off the NEC Express5800/ft series and unplug the both power cords.
23.
Remove the both PCI modules (#1 and #2) from the NEC Express5800/ft series (see page
24.
8-31 "Removing PCI Module").
Open the top cover of the PCI Module #1.
25.
Make setting of jumper switch for clearing CMOS.
26.
Remove the clips from the jumper pins 11-12 and place them on the jumper pins 1-2 on
the PCI Module #1.
Mount only the PCI Module #1 to the NEC Express5800/ft series (see page 8-33
27.
"Installing PCI Module").
Plug the both power cords and when the POWER Switch LED turns on, press it to power
28.
on the server.
When the following message appears after startup, press [CONTINUE].
29.
WARNING
Advertisement
Table of Contents
