Tcm Error Messages - Symbol PDT 8100 Series Product Reference Manual

Error Text
Wrong destination code
File type does not support
IPL auto-select
Non-contiguous record
found
Timed Out - No data
Fail: Buffer Overrun
Invalid file format

TCM Error Messages

TCM validates the cells in the partition table when the Execute button is clicked. Cells
highlighted in red contain an error. Partition loading is disabled until all errors are corrected.
Error
Failed to build images: flash
file system DLL not loaded!
Failure finding directory xxx Building process failed because directory xxx was not found.
Table 11-2. IPL Errors (continued)
Error Number
-28
-29
-30
-31
-32
-33
Table 11-3. TCM Error Messages
TCM could not load the DLL required to build images for the targeting
flash file system. Reinstall TCM or recover the DLL.
Configuring The Terminal
Probable Cause
A specific partition was chosen from the
Main Menu (not Auto Select) but the file
selected for download was for another
partition. Ensure that the partition selected
from the Main Menu matches the file
selected for download.
IPL auto-select is only valid for Symbol HEX
files. Only use Auto-Select with Symbol HEX
files.
A Symbol HEX file download was attempted
but the HEX file is invalid. Ensure the file is
in Symbol HEX file format.
IPL was waiting for data from the source
device but timed out before receiving any.
Check the source device connectivity and
retry.
The serial port device could not keep up with
incoming data. Retry the serial download
with a lower baud rate.
The file format is invalid. Ensure the
downloaded file is in a format that is
acceptable to IPL (Symbol HEX, BIN or
BGZ).
Description/Solution
11-25