Spectrum24 Network Configuration
Introduction
Wireless LANs allow PDT 8100 series terminals to communicate wirelessly, and to send
captured data "real time" to a host device. Before a terminal can be used on a Spectrum24
LAN the facility must be set up with the equipment required to run the wireless LAN and the
terminal must be properly configured. Refer to the documentation which came with the APs
for instructions on setting up the required hardware.
The terminal Spectrum24 settings, NICTT settings and Mobile Companion settings
configure and monitor the Spectrum24 connection. To set up the PDT 8142, refer to
Configuring the PDT 8142 (2 MB Radio)
on page 9-4. To set up the PDT 8146, refer to
Configuring the PDT 8146 (11 MB Radio)
on page 9-21.
9-3