Symbol PDT 8100 Series Product Reference Manual page 125

a. Connect the modular end of the cable (p/n 170013-000) plus a null modem
adapter between the expansion port of the cradle and a COM port on a host
computer.
b. Start a terminal emulation session on the host computer. Use standard terminal
emulator software, such as ProComm
emulation settings: 115200 bps, 8N1, XON/XOFF flow control, ASCII file
transfer protocol.
c. Power up the cradle. Before the power-up LED sequence begins, press a from
the terminal program to load the Cradle Utilities configuration interface. The
following screen appears on the host computer
Cradle Utilities version x.xx
Firmware Datacode xxxxxxxx
1: Public network settings
2: Advanced settings
3: PPP settings
4: Private network settings
5: Firmware Download
Select a submenu OR:
Q: Discard changes and restart
F: Save changes and restart
2. Type 1 to display the Public network settings menu
Public network settings
1: Static Mode: 0
2: NAPT Mode: 1
The following settings are only used when Static
mode is 1
3: Cradle IP Address: 0.0.0.0
4: Router (Gateway) IP Address: 0.0.0.0
5: 1st DNS IP Address 0.0.0.0
6: 2nd DNS IP Address 0.0.0.0
7: 1st WINS IP Address 0.0.0.0
8: 2nd WINS IP Address 0.0.0.0
9: Subnet Mask: 0.0.0.0
The following settings are only used when NAPT mode
is 0 and Static mode is 1
A: Terminal 1 IP Address 0.0.0.0
B: Terminal 2 IP Address 0.0.0.0
C: Terminal 3 IP Address 0.0.0.0
D: Terminal 4 IP Address 0.0.0.0
E:Expansion Port IP Address: 0.0.0.0
3. At the Public network settings menu:
a. Press 1 and set Static Mode to 1.
TM
or Hyperterminal
:
:
Communications
TM
. Use terminal
4-29