Table of Contents
Advertisement
The emulation should be listed in the Options section of the printer's star-
tup page, in the Administration/Emulation printer's configuration menu,
and on the advanced status page.
Downloading an Emulation via an Ethernet Interface
5 "
Before you begin this procedure, your printer and PC (or UNIX work-
station) must be connected to an Ethernet network running TCP/IP
and have valid IP addresses.
1
Turn on the printer, and wait for IDLE to display in the message window.
2
If your PC is running Windows, change to DOS.
3
Insert the emulation CD-ROM or disk in your PC, and change to that drive
(for example, if you're using the D drive, type d: ).
If you want to download the emulation from a UNIX workstation, copy the
installation file from the emulation CD-ROM or disk to a temporary direc-
tory on your UNIX workstation, then change to that directory.
4
Open an ftp session on your PC or workstation by typing one of the follow-
ing commands:
5
When prompted for a user name and password, press Enter for both.
An ftp> prompt displays.
6
At the ftp> prompt, change to binary mode by typing
7
At the ftp> prompt, send the emulation file to the printer's hard disk by
typing
where filename is the name of the installation file.
The printer's message window reads 1 ACTIVE JOB to indicate that the
emulation is being downloaded to the hard disk. The ftp> prompt returns
when the emulation has finished loading.
8
At the ftp> prompt, end the ftp session by typing
9
When the Disk light stops flashing and the printer's message window
reads IDLE for at least 30 seconds, turn the printer off and then on again.
10
When downloading is complete and the printer returns to the idle status,
reboot the printer.
Emulations, Fonts, and Other Software
ftp printername
ftp ipaddress
bin
put filename
quit
(for example, ftp pctdev6 )
(for example, ftp 161.33.130.45 )
127
Advertisement
Table of Contents
