Expansion Board Removal; Removing An Expansion Board - NEC PowerMate VT 300i Series Service And Reference Manual

Expansion Board Removal

Remove any installed expansion board(s) as follows.
1. Remove the left side cover (see "Removing the Left Side Cover" earlier in
this section).
2. Label and disconnect any cables connected to the expansion board.
3. Remove and save the screw securing the board to the support bracket.
4. Pull the expansion board out of its connector and expansion slot. Set the
board on an antistatic surface or store in an antistatic bag.
A – Screw
B – Expansion Board
5. Install a new board or, if not installing a board, install the previously
removed slot cover.
6. Place the slot cover over the slot and secure it with the slot cover screw.
7. Replace the left side cover (see "Replacing the Left Side Cover" earlier in
this section).
3-8 Disassembly and Reassembly

Removing an Expansion Board

C – System Board