1/2-Inch Diskette Drive Removal; Removing The Hard Drive - NEC PowerMate VT 300i Series Service And Reference Manual

3 1/2-Inch Diskette Drive Removal

Remove the 3 1/2-inch diskette drive as follows.
1. Remove the left side cover and the front panel (see "Removing the Left Side
Cover" and "Front Panel Removal" earlier in this section).
2. Label and unplug the signal and power cables from the back of the diskette
drive.
Note
power cables are keyed to fit only in the correct position.
3. Remove the two screws holding the diskette drive to the diskette drive
bracket.
4. Slide the diskette drive out of the chassis.
3-20 Disassembly and Reassembly

Removing the Hard Drive

A – Screws
:
When reinstalling the diskette drive, note that all
B – Top Bracket