Power On Mode jumper JP1 is a two-pin block for setting how the system
powers up. Depending on the jumper setting, the system powers up when the
power button is pressed or when the power cord is connected. The factory
settings are shown in the following table.
Function
Power
Button Boot
Power Cord
Boot
Clear CMOS jumper JBAT1 is a three-pin block for clearing the CMOS and
system password. The factory settings are shown in the following table.
To prevent damage to the system board, do not clear CMOS
and password while power is on.
Function
Normal
Clear
CMOS and
Password
Wake-On LAN jumper JWOL is a three-pin jumper block for use with a
network board. The factory settings are shown in the following table.
Function
Enable
Disable
2-6 System Configuration
Power On Mode Jumper JP1 Settings
Jumper Pins
Description
1 and 2
Enables system power on when the power button is
pressed. Factory setting: pins 1 and 2 jumpered.
Open
Enables system power on when the power cord is
connected.
! CAUTION
Clear CMOS Jumper JBAT1 Settings
Jumper Pins
Description
1 and 2
Disables Clear CMOS and Password function. Factory
setting: pins 1 and 2 jumpered.
2 and 3
Enables Clear CMOS and Password function.
Wake-On LAN Jumper JWOL Settings
Jumper Pins
Description
1 and 2
Enables onboard Wake-On LAN. Factory setting: pins 1
and 2 jumpered.
2 and 3
Disables onboard Wake-On LAN.