Installing The Celeron Or Pentium Iii Processor Cartridge - NEC PowerMate VT 300i Series Service And Reference Manual

2. Align the replacement cartridge with the top of the retention mechanism so
that the notch in the cartridge connector aligns with the key in the Slot 1
connector.

Installing the Celeron or Pentium III Processor Cartridge

A – Processor Cartridge
B – Retention Mechanism
3. Insert the cartridge into the retention mechanism and evenly press down on
the cartridge until it fully seats in the Slot 1 connector.
4. If the processor cartridge has an attached cooling fan, plug the fan cable into
its connector (CPUFAN) on the system board.
5. Set the processor jumpers on the system board for the processor type
installed (see "Processor Jumper Settings" in Section 2).
6. Reinstall any expansion boards that may have been removed.
7. Replace the left side cover (see "Replacing the Left Side Cover" earlier in
this section).
8. Connect any peripherals and power cords, and power up the system.
3-14 Disassembly and Reassembly
C – Slot 1 Connector
D – Key