Internal Connectors and Sockets
Locations of the internal connectors and sockets on the system board are shown
in the following figure.
System Board Internal Connector and Socket Locations
A – AGP Board Connector
B – PCI Connectors
C – ISA Connector
D – Processor Socket
System Board Jumpers
The system board contains four configuration jumper blocks:
T
Processor/Bus Speed jumper block SW1
T
Power On Mode jumper block JP1
T
Clear CMOS jumper block JBAT1
T
Wake-Up on LAN jumper block JWOL.
The following figure shows the location of the jumper blocks on the system
board. To reset the jumper blocks, see the following paragraphs. (The factory-
set jumper settings are included in Section 2, "System Configuration.")
E – Memory Sockets 1 and 2
F – Diskette Drive Connector
G – Secondary IDE Connector
H – Primary IDE Connector
System Board 4-3