Handlebar Height Adjustment; Steering Speed Ratio Adjustment; Recommended Gasoline - Arctic Cat 2014 SNO PRO 500 Operator's Manual

4. To move the right-side handlebar forward, tap the
steering post mount plate to the left.
5. To move the left-side handlebar forward, tap the
steering post mount plate to the right.
6. Verify handlebar alignment; then tighten the two
cap screws to 16-18 ft-lb.
HANDLEBAR HEIGHT
ADJUSTMENT
The steering post has two mounting locations to
change the position of the handlebar: low and high.
To change the position of the handlebar, use the fol-
lowing procedure:
1. Remove the two cap screws securing the steering
post to the mounting bracket.
2. Move the handlebar to the desired position; then
install and tighten the cap screws to obtain a good
"fit" of the bearings to the steering post.
NOTE: The amount the cap screws are tightened
to the adjustment block will affect the "fit" of the
bearings to the steering post. Make sure the fit is
not too tight or too loose.
18
STEERING SPEED RATIO
ADJUSTMENT
NOTE: The lower steering post bearing housing is
not symmetrical; therefore, rotating it 180° moves
the steering post closer to or farther away from the
drag link which changes the steering ratio. The
lower speed ratio (standard position) is when the
steering post is adjusted closest to the drag link.
1. Remove the hood, side access panels, and the air
silencer assembly.
2. Remove the two bearing housing cap screws, the
743-092A
roller cap screw, and the two upper steering post
mounting block cap screws.
0743-090
3. Rotate the steering post so the steering arm comes
free from the drag link; then lift the steering post
slightly and rotate the lower bearing housing 180°
to a new position.
4. Install the two bearing housing cap screws, the roller
cap screw, and the two upper steering post mounting
block cap screws. Tighten hardware to 20 ft-lb.
5. Verify handlebar alignment (see Handlebar Align-
ment in this sub-section).

RECOMMENDED GASOLINE

Use a 100:1 premix fuel in the gas tank during break-in
or engine damage may occur.
CAUTION
743-093A
743-094A