Rail Wear Strip - Arctic Cat 2014 SNO PRO 500 Operator's Manual

3. Remove the lock nuts securing the wear bar to the
ski.
4. Remove the wear bar from the ski.
Installing Ski Wear Bar
1. Move the wear bar into position on the bottom of
the ski.
2. Align the wear bar studs with the holes in the ski;
then install the lock nuts. Tighten to 11-15 ft-lb.

RAIL WEAR STRIP

Arctic Cat recommends that the wear strips be checked
weekly and replaced as necessary. Measure the wear
strips at 25.4 cm (10 in.) intervals. Wear strips must be
10.7 mm (0.42 in.) thick or thicker. If wear strip mea-
surements are less than specified, replacement of both
wear strips is necessary to prevent premature track clip
wear and possible track damage.
NOTE: The rail wear strips will wear rapidly if the
snowmobile is operated on terrain on which the
snow cover is minimal. Loose snow is required to
cool and lubricate the wear strips and prevent
accelerated wear.
0743-185
0744-875
71