Preparation After Storage; Genuine Arctic Cat Products - Arctic Cat 2014 SNO PRO 500 Operator's Manual

16. If the snowmobile must be stored outdoors, posi-
tion the snowmobile out of direct sunlight; then
block the entire snowmobile off the ground mak-
ing sure the snowmobile is secure. Loosen the
track adjusting bolts to reduce track tension. Cover
with a machine cover or a heavy tarpaulin to pro-
tect it from dirt, dust, and rain.
CAUTION
Avoid storing in direct sunlight and using a plastic
cover as moisture may collect on the snowmobile
causing corrosion.
Preparation After
Storage
Taking the snowmobile out of storage and correctly
preparing it for another season will assure many miles
and hours of trouble-free snowmobiling. Arctic Cat
recommends the following procedure.
1. Clean the snowmobile thoroughly. Polish the exte-
rior of the snowmobile.
2. Clean the engine. Remove the cloth from the
exhaust system. Check exhaust system and air-
intake silencer for obstructions.
3. Inspect all control wires and cables for signs of
wear or fraying. Replace if necessary. Use cable
ties or tape to route wires and cables away from
hot or rotating parts.
4. Inspect the drive belt for cracks and tears. Check
belt specifications. Replace if damaged or worn.
Install the drive belt.
NOTE: If the old belt is worn but in reasonable
condition, keep it in the tool box as a spare in case
of emergency.
5. Inspect all fuel hoses for deterioration or cracks;
replace if necessary. Make sure all connections are
tight.
6. Inspect the entire brake system (fluid level, pads,
etc.), all controls, headlight, taillight, brakelight,
ski alignment, ski wear bars, and headlight aim;
adjust or replace as necessary.
7. Inspect the spark plugs. Replace, gap, or clean as
necessary.
8. Adjust the track to the proper tension and align-
ment.
NOTE: Prior to tipping the snowmobile on its
side, apply the brake and set the brake lever lock.
9. Check air pressure in the front ski shocks.
10. Verify for properly adjusted throttle cable and oil
pump cable.
11. Tighten all nuts, bolts, and cap screws making sure
all calibrated nuts, bolts, and cap screws are tight-
ened to specifications.
12. If not done during preparation for storage, lubri-
cate the rear suspension, spindles, and steering
arms with an all-temperature grease.
Genuine Arctic Cat
Products
Arctic Cat Oil - Developed, tested, and proven espe-
cially for Arctic Cat Snowmobile engines. Arctic Cat
Oil is the only oil authorized by Suzuki and Arctic Cat
engineers for use in Arctic Cat Snowmobile engines.
Arctic Cat Oil ensures warranty coverage for lubricat-
ing related incidents. Arctic Cat Oil comes in strong,
handy, recloseable containers.
Transmission Lube - A special formula that reduces
friction and fights corrosion. Arctic Cat Transmission
Lube comes in easy-pour, recloseable containers.
Synthetic Chain Lube - A special formula reduces
friction and fights chain case corrosion.
Fuel Stabilizer - Fuel treatment for storage longer
than 60 days. Slows oxidation to prevent gum and var-
nish buildup. Engines start easily even after storage
periods exceeding one year. Ideal for use in snowmo-
bile gas tanks.
Antifreeze - Pre-mixed ready for use without adding
any water. Comes in 1 gallon container.
Hi-Temp Brake Fluid - Recommended for Arctic Cat
hydraulic brake system.
Container
Product
Synthetic APV 2-Cycle Oil
Synthetic APV 2-Cycle Oil
Synthetic APV 2-Cycle Oil
Synthetic APV 2-Cycle Oil 2-1/2 gal.
Synthetic APV 2-Cycle Oil
Formula 50 Oil
Synthetic Chain Lube
Transmission Lube
Engine Storage Preserver
All-Temp Grease (Lithium) 14-1/2 oz
Silicone Spray
Shock Oil - Light (Fox Racing)
Fuel Stabilizer
Hi-Temp Brake Fluid
Antifreeze
Fuel System Cleaner
Shock Oil
Part Pkg/Qty
Size Number
55 gal. 2639-509 1
1 gal. 2639-511 6/1 gal.
16 gal. 2639-510 1
2639-975 2—2-1/2 gal.
1 qt 2639-512 12/1 qt.
1 qt 5639-475 –
8 oz 5639-038 –
12 oz 0636-817 12/12 oz
12 oz 0436-888 12/12 oz
4639-365 10/14-1/2 oz
10 oz 0636-594 12/10 oz
1 qt 4639-345 1 qt
8 oz 0436-907 12/8 oz
12 oz 0436-908 6/12 oz
1 gal. 0436-909 6/1 gal.
12 oz 3639-619 1
1 qt 5639-240 1 qt
73