Arctic Cat 2014 SNO PRO 500 Operator's Manual page 37

3. Using Drive Clutch Bolt Tool (p/n 0644-281),
remove the torx screw and lock washer securing
the drive clutch to the crankshaft; then remove the
cap screw securing the driven clutch to the shaft.
4. Using Clutch Puller (p/n 0744-062) and an impact
wrench or breaker bar and Spanner Wrench (p/n
0644-136), tighten the puller. If the drive clutch
will not release, sharply strike the head of the
puller. Repeat this step until the clutch releases.
Remove the clutches and the drive belt.
CAUTION
Use Clutch Puller (p/n 0744-062). Never substitute a
different puller or drive clutch damage will occur.
5. Remove the cap from the coolant filler neck; then
using Vacuum Test Pump (p/n 0644-131) or a suit-
able substitute, drain the engine coolant.
6. Remove the heat wrap from the throttle bodies and
the cable ties securing the harness cover; then
remove the cover and disconnect the five harness
connectors.
NOTE: For installing purposes, note the loca-
tions of the cable ties securing the harnesses.
7. Remove the four lock nuts and cap screws securing
RS067A
the oil tank to the chassis; then disconnect the low
oil sensor from the back side of the tank. Remove
the oil hose from the oil pump and discard the
clamp. Plug the oil line and remove the oil tank.
RS068
8. Loosen the clamp and remove the throttle body
coolant hose (A); then loosen the clamp and
remove the gasline hose (B) from the delivery pipe
of the throttle body assembly. Clamp or close off
the gasline hose.
Since the fuel supply hose may be under pressure, remove
it slowly to release the pressure. Place an absorbent
towel around the connection to absorb gasoline; then
remove the hose slowly to release the pressure. Always
wear safety glasses when removing the fuel hoses.
! WARNING
IO035A
IO037A
IO039A
33