Arctic Cat 2014 SNO PRO 500 Operator's Manual page 56

CAUTION
Make sure all wiring harnesses and gasline hoses are
properly routed to avoid premature wear and/or con-
tact with exhaust components.
12. Place the recoil starter with ground wire into posi-
tion and secure the starter with six cap screws.
Tighten to 96 in.-lb.
13. Lubricate the threads of the drive clutch bolt with
a light film of oil; then place the drive clutch into
position on the crankshaft and secure with the cap
screw and lock washer. Tighten to 51 ft-lb.
NOTE: Before installing the drive clutch, be sure
to wipe both the crankshaft taper and clutch
mounting taper clean using a clean towel.
CAUTION
When installing the drive clutch, do not tighten the
clutch cap screw with any kind of impact tool Tighten
cap screw using a hand torque wrench only. Failure to
do so could result in stationary sheave damage.
14. Install the driven clutch, key, and stub shaft.
Secure with a cap screw (coated with blue Loctite
#243) and washer. Tighten to 20 ft-lb.
NOTE: A small amount of Loctite Anti-Seize
Thread Compound (p/n 0678-146) applied to the
driven shaft will aid in future driven clutch
removal.
15. Check clutch alignment.
52
16. Using Drive Belt Deflection Tool (p/n 0644-424),
install the drive belt so the part number can be
read; then roll the belt back and forth while closing
the sheaves allowing the sheaves to fully close.
Verify proper drive belt deflection.
IO035A
17. Apply a thin coat of high-temperature silicone
sealant to each exhaust port; then install the
exhaust gaskets.
18. Apply a thin coat of high-temperature silicone
sealant to the mating surfaces of the exhaust mani-
fold; then install the exhaust manifold and secure
with flange nuts. Tighten the nuts in a crisscross
pattern to 17 ft-lb.
19. Install the resonator and secure it to the chassis
with the springs and hairpin clip.
IO034A
20. Install the expansion chamber and secure with the
springs; then install the link to the upper spar with
cap screw and tighten to 96 in.-lb.
743-067B
IO033A
IO032A