Handlebar Height/Tilt (M 8000 Sno Pro/Ltd/ Xf 8000 High Country) - Arctic Cat ZR 5000 Operator's Manual

Code Trouble
2 Failure in injector(s).
4 Open or short circuit in barometric
pressure sensor.
5 Open or short circuit in intake air tem-
perature sensor.
6 Open or short circuit in water tempera-
ture sensor.
7 Open or short circuit in throttle position
sensor.
12 Failure in ignition coil(s).
16 Incorrect adjustment/failure in APV
cable.
17 Failure in exhaust temperature sensor.
18 Failure in servomotor.
21 Open or short circuit in/or loose knock
sensor.
OCTN Low octane gasoline.
5000/9000
These diagnostic codes are displayed on
the readout screen incorporated within
the speedometer/tachometer. Refer to the
following chart for diagnostic codes.
Code Trouble
1 Failure in the fuel system.
2 Failure in injector (PTO).
3 Failure in injector (MAG).
4 Failure in barometric pressure sensor.
5 Open or short circuit in intake mani-
fold air temperature sensor.
6 Open or short circuit in water temper-
ature sensor.
7 Open or short circuit in throttle posi-
tion sensor.
8 Open or short circuit in manifold air
pressure sensor.
9 Failure in crankshaft position sensor.
11 Failure in speed sensor.
12 Failure in coil (MAG).
13 Failure in coil (PTO).
14 Failure in ISC valve.
15 Failure in oxygen sensor.
19 Failure in camshaft position sensor.
21* Open or short circuit in/or loose knock
sensor.
22* Failure in injector (PTO secondary).
23* Failure in injector (MAG secondary).
25 Failure in shifting system/gear position
switch.
26 Malfunction in air pressure sensor.
29 Malfunction in shift control switch.
OCTN* Low octane gasoline.
* 9000
Handlebar Height/Tilt
(M 8000 Sno Pro/LTD/
XF 8000 High Country)
To adjust handlebar height, use the fol-
lowing procedure:
1. From each side of the steering post,
compress the locking tabs to unlock
the handlebar.
2. With the tabs compressed, adjust the
handlebar up or down to the desired
position; then release the tabs to lock
the handlebar in place.
NOTE: When the desired height is
found, make sure that the lock collar
is seated in the grooves by lifting up
and pressing down on the handlebar.
To adjust handlebar tilt, use the following
procedure:
1. Loosen the four cap screws and tilt
the handlebar to the desired position.
2. Tighten the four cap screws evenly
to 15 ft-lb.
! WARNING
Tighten the cap screws according to
specifications to prevent unexpected
"movement" of the handlebar during
operation over rough terrain. DO NOT
position handlebar so steering (maxi-
mum right/left turning capabilities) or
throttle and brake controls are affected.
0747-618
0747-617
13