Section 04 ENGINE (DI)
Subsection 05 (TOP END)
USED PISTON MEASUREMENT
Note the measurement on the piston dome.
1. Piston dome
2. Piston measurement
Using a micrometer, measure piston skirt perpen-
dicularly (90°) to piston pin according to the follow-
ing table.
ENGINE TYPE
947 DI
A
F01D0NA
1. Measuring perpendicularly (90°) to piston pin axis
A. See previous table
ENGINE TYPE
All
04-05-8
MAXIMUM A
mm (in)
24 (.945)
1
MAXIMUM PISTON
SKIRT WEAR
mm (in)
0.12 (.005)
The measured dimension must not be less than
0.12 mm (.005 in) of the one scribed on piston
dome. Otherwise, install a new piston.
Piston/Cylinder Wall Clearance
Used and New Pistons
IMPORTANT: Make sure used piston is not worn
more than specified. See USED PISTON MEA-
SUREMENT above.
To determine the piston dimension, take the mea-
surement on the piston dome.
1. Piston dome
2. Piston measurement
Adjust and lock a micrometer to the specified val-
ue on the piston dome.
1. Micrometer set to the piston dimension
With the micrometer set to the piston dimension,
adjust a cylinder bore gauge to the micrometer di-
mension and set the indicator to zero.
www.SeaDooManuals.net
SMR2002-062_04_05A.FM