Anticorrosion Treatment - Sea-doo GTX DI 5563 2002 Shop Manual

At this point, install a hose pincher on bleed outlet
hose.
1. Bleed outlet hose
Continue to pour until antifreeze flows in air com-
pressor water outlet hose.
1. Air compressor water outlet hose
Remove pinchers in this order to allow proper flow
of antifreeze.
1. Bleed outlet hose.
2. Crankcase cooling cover outlet hose.
3. Engine cylinder drain hose.
4. Water outlet hose.
SMR2002-057_02_05A.FM
Pour approximately 200 mL (7 oz) of antifreeze in
the water regulator valve supply hose to allow an-
tifreeze flowing through the valve and into muffler
to protect it.
Remove temporary hose and reconnect engine
water outlet hose.
Most of the antifreeze will drain out when removing
the hose pinchers. Use a container to recover it. DIS-
POSE ANTIFREEZE AS PER YOUR LOCAL LAWS
AND REGULATIONS.
NOTE: Although antifreeze will mainly drain out,
the antifreeze has mixed with the water that was
possibly trapped in the cylinder water jackets and
thus preventing freezing problems.
At preseason preparation, drain the remaining an-
tifreeze from cooling system prior to using the wa-
tercraft.
4-TEC Engines
Refer to the COOLING SYSTEM section.

ANTICORROSION TREATMENT

All Engines
Wipe off any residual water in the engine compart-
ment.
Spray BOMBARDIER LUBE lubricant over all me-
tallic components in engine compartment.
Lubricate the throttle cable with BOMBARDIER
LUBE lubricant.
The seat should be partially left opened during
storage. This will avoid engine compartment con-
densation and possible corrosion.
www.SeaDooManuals.net
Section 02 MAINTENANCE
Subsection 05 (STORAGE)
02-05-5