Storage; Engine Draining; Propulsion System; Fuel System - Sea-doo GTX DI 5563 2002 Shop Manual

STORAGE

DI Models

ENGINE DRAINING

Disconnect the quick connect fitting. Press both
tabs and pull fitting.
DISCONNECT THIS HOSE
Lower hose as necessary so that draining can take
place.
Reconnect fitting when done.
Also ensure air compressor drain line is not ob-
structed. Clean as necessary.

PROPULSION SYSTEM

Jet Pump
Lubricant in impeller shaft reservoir should be
drained. Reservoir should be cleaned and refilled
with SEA-DOO synthetic 75W90 GL5 polyolester
oil. Refer to JET PUMP for proper procedure.
CAUTION: Use only SEA-DOO jet pump oil or
equivalent synthetic gear oil, otherwise com-
ponent service life could be reduced. Do not
mix oil brands or types.
SMR2002-057_02_05A.FM
PTO Flywheel
Remove PTO flywheel guard.
Lubricate PTO flywheel at grease fitting with syn-
thetic grease (P/N 293 550 010).
CAUTION: Do not lubricate excessively. Imme-
diately stop when a slight movement is noticed
on rubber boot.
1. Grease PTO flywheel
CAUTION: Never leave any clothing, tool or oth-
er objects near PTO flywheel and drive shaft.

FUEL SYSTEM

All Engines
Verify fuel system. Check fuel lines and injectors
for leaks. Replace damaged hoses or clamps if
necessary.
Sea-Doo Fuel Stabilizer (P/N 413 408 600) or equiv-
alent should be added in fuel tank to prevent fuel
deterioration. Follow manufacturer's instructions
for proper use.
Fill up fuel tank completely. Ensure there is no wa-
ter inside fuel tank.
CAUTION: Should any water be trapped inside
fuel tank, severe internal damage may occur to
the fuel injection system.
CAUTION: Fuel stabilizer should be added prior
to engine lubrication to ensure fuel system com-
ponents protection against varnish deposits.
www.SeaDooManuals.net
Section 02 MAINTENANCE
Subsection 05 (STORAGE)
0
02-05-1