Finition Plate; Inlet Grate; Riding Plate - Sea-doo GTX DI 5563 2002 Shop Manual

FINITION PLATE

Removal and Installation
For GTX 4-TEC and GTX DI
Removal procedure for RH finition with grill and LH
finition with grill is same.
Remove two darts holding the grill with body.
Make a hole in the luggage compartment as shown
in the illustration below to get access of finition
plate screw.
Remove the screw and remove finition plate.
After installing finition plate, plug (P/N 291 000 279)
the finition plate screw hole.
1. Plug (P/N 291 000 279)
For GTX 4-TEC Limited Edition
Removal procedure for RH finition, deflector with
grill and LH finition, deflector with grill is same.
Finition plate is mounted on deflector.
Remove three darts holding deflector and grill.
SMR2002-092_14_02A.FM
Subsection 02 (ADJUSTMENT AND REPAIR)

INLET GRATE

Removal and Installation
Loosen screws and remove inlet grate.
NOTE: An impact screwdriver should be used to
loosen tight screws.
When reinstalling inlet grate, apply Loctite 271 on
threads.
Follow this sequence referring to the illustration:
Hand tighten screw numbers ➀, ➁, ➂ then ➃.
Torque screw numbers ➀, ➁ and ➂ to 11 N•m
(97 lbf•in).
Torque screw number ➃ to 26 N•m (19 lbf•ft).

RIDING PLATE

Removal
All Models
Remove inlet grate.
Remove jet pump. Refer to JET PUMP.
Remove the speed sensor from the riding plate (if
applicable).
Loosen riding plate screws.
NOTE: An impact screwdriver should be used to
loosen tight screws.
Using a low height hydraulic bottle jack and 2 steel
plates, pry out riding plate.
www.SeaDooManuals.net
Section 14 HULL/BODY
14-02-11