Operation - Hilti SF 2-A Original Operating Instructions

6.5 Transport and storage of battery packs
Remove the battery from the tool before transport or storage. Make sure that
the battery contacts are not short-circuited. Remove loose metal items such
as screws, nails, clamps, loose screwdriving bits, wires or metal cuttings
and chips from the toolbox or transport container, or prevent these items
from coming into contact with the battery.
Observe national and international transport regulations when shipping
battery packs (transportation by road, rail, sea or air).
6.6 Belt hook 3
CAUTION
Check that the belt hook is fitted securely before beginning work.
The belt hook allows the power tool to be attached to a belt worn by the
operator. The belt hook can also be fitted to the other side of the power tool
for use by left-handed persons.
1. Remove the battery from the tool.
2. Fit the mounting plate into the guides provided.
3. Secure the belt hook with the two screws.

7 Operation

CAUTION
The tool may get hot during use. Wear protective gloves.
CAUTION
When drilling and screwdriving, the grip of the tool may be deflected
laterally (the tool tends to pivot about its own axis).
CAUTION
To avoid injuries caused by the insert tool, wear protective gloves when
changing insert tools.
7.1 Setting forward or reverse rotation
NOTE
The forward / reverse switch is used to select the direction of rotation of the
drive spindle. An interlock prevents switching while the motor is running.
The control switch is locked when the forward / reverse switch is in the
Printed: 24.03.2014 | Doc-Nr: PUB / 5174884 / 000 / 00
4
en
39