Operation - Hilti TE 2 Manual

4.1 Noise information and vibration values in accordance with EN 62841
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools, or is poorly maintained, the data can vary. This can
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the power tool is switched
off, or when it is running but not actually being used for a job. This can significantly reduce exposure over
the total working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
Noise information
Sound power level (L
WA
Uncertainty for the sound power level (K
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Vibration information
Vibration emission value for hammer drilling in concrete (a
Vibration emission value for drilling in metal (a
Uncertainty for the given vibration value (K)
5

Operation

Fitting the side handle
CAUTION
Risk of injury! The depth gauge, if fitted but not used, might hinder the operator.
▶ Remove the depth gauge from the tool.
CAUTION
Risk of injury! Loss of control over the product.
▶ Check that the side handle is fitted correctly and tightened securely. Check that the clamping
band is engaged in the groove in the product.
TE 2-M
Fitting / removing the chuck
Fitting/removing the drill bit or other accessory: SDS chuck
Use of unsuitable grease may cause damage to the product. Use only the
recommended grease supplied by Hilti.
TE 2-M
Fitting/removing the drill bit or other accessory: Quick-release chuck
Adjusting the depth gauge
Always pay attention to the maximum length of the depth gauge.
Drilling with hammering action (hammer drilling)
TE 2-S
Light hammering action
6 English
)
)
WA
)
pA
)
pA
h, D
)
h, HD
)
2059547
*2059547*
102.1 dB(A)
3 dB(A)
91.1 dB(A)
3 dB(A)
12.1 m/s²
2.8 m/s²
1.5 m/s²
2
3
4
5
6
7
7