2. To switch the light on for 2 minutes, simultaneously press the mode selector and the control switch for
at least 0.5 seconds.
▶ The LEDs for the mode indicator go out.
6
Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1
Setting forward or reverse rotation
In the middle position, the forward / reverse selector switch serves as a switch-on interlock.
▶ Set the forward / reverse selector switch to forward or reverse rotation.
6.2
Switching on
▶ Press the control switch.
▶ Speed of rotation is regulated by the distance the control switch is pressed in.
6.3
Screwdriving
CAUTION
Risk of injury by damaged workpieces! Screws or workpiece can be damaged if torque is too high. This
presents a risk of injury.
▶ Make sure that screws and workpiece are suitable for the torque produced by the product.
▶ Set the forward/reverse switch to the desired direction of rotation.
▶ Be sure to use the correct adapter.
6.4
Switching off
▶ Release the control switch.
7
Care and maintenance
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care of the product
•
Carefully remove stubborn dirt.
•
Carefully clean the air vents, if present, with a dry, soft brush.
•
Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
•
Use a dry, clean cloth to clean the contacts of the product.
Care of the Liion batteries
•
Never use a battery with clogged air vents. Clean the air vents carefully using a dry, soft brush.
•
Avoid unnecessary exposure of the battery to dust and dirt. Never expose the battery to high levels of
moisture (e.g. by being dipped in water or left in the rain).
If a battery has been soaked by moisture, treat it as a damaged battery. Isolate it in a non-flammable
container and consult Hilti Service.
•
Keep the battery free of extraneous oil and grease. Do not permit dust or dirt to accumulate unnecessarily
on the battery. Clean the battery with a dry, soft brush or a clean, dry cloth. Do not use cleaning agents
containing silicone as these can attack the plastic parts.
Do not touch the contacts of the battery and do not remove the factory-applied grease from the contacts.
•
Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
22
English
4
2356008
*2356008*