Operation - Hilti SIW 22T-A 1/2 Operating Instructions Manual

5

Operation

5.1 Preparations at the workplace
5.1.1 Charging the battery
1. Before charging the battery, read the operating instructions for the
charger.
2. Make sure that the contacts on the battery and the contacts on the
charger are clean and dry.
3. Use an approved charger to charge the battery.
5.1.2 Inserting the battery
CAUTION
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery
and the contacts on the product are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the battery holder until it engages with an audible
click.
3. Check that the battery is seated securely.
5.1.3 Removing the battery
1. Press the battery release buttons.
2. Remove the battery from the tool.
5.1.4 Fitting the belt hook (optional)
WARNING
Risk of injury! Hazard presented by a falling power tool.
▶ A falling power tool may present a risk of injury to yourself and others.
Check that the belt hook is fitted securely before beginning work.
The belt hook allows the power tool to be attached to a belt worn by
the operator. The belt hook can be fitted to allow attachment on the left
or right side of the body.
1. Disconnect the battery from the tool.
2. Fit the mounting plate into the guides provided.
3. Use the 2 screws to attach the belt hook and make sure that the screws
are driven fully (countersunk head flush).
5.1.5 Setting forward or reverse rotation
In the middle position, the forward / reverse selector switch serves as a
safety lock.
*2153646*
2
2153646
3
English 9