Disassembling And Servicing; Preparation; Separating Clutch Housing - wsm B2420 Workshop Manual

B2420, WSM

4. DISASSEMBLING AND SERVICING

[1] PREPARATION

(1) Separating Clutch Housing

Mid Mounting ROPS [If Equipped]
• See page 1-S19.
Draining Transmission Fluid
1. Place an oil pan underneath the transmission case, and remove
the drain plugs (1).
2. Drain the transmission fluid.
3. Reinstall the drain plugs (1).
(When refilling)
• Fill new oil from filling port after removing the filling plug (2) up
to the upper notch on the dipstick (3).
• After running the engine for few minutes, stop it and check the
oil level again, if low, add oil prescribed level.
IMPORTANT
• Use only multi-grade transmission oil. Use of other oils
may damage the transmission or hydraulic system. Refer
to "LUBRICANTS, FUEL AND COOLANT" (See page G-8).
• Never work the tractor immediately after changing the
transmission oil. Keeping the engine at medium speed for
a few minutes to prevent damage to the transmission.
• Do not mix different brands oil together.
Transmission fluid Capacity
(1) Drain Plug
(2) Filling Plug
(3) Dipstick
3-S4
TRANSMISSION
9Y1210436CLS0005US0
14 L
3.7 U.S.gals
3.1 lmp.gals
A: Oil level is acceptable within this
range
9Y1210436ENS0023US0
KiSC issued 06, 2012 A