wsm B2420 Workshop Manual page 162

B2420, WSM
Universal Joint
1. Loosen the clamp (2) and slide the universal joint cover (1) to
the rear.
2. Tap out the spring pins (3).
3. Disconnect the bearing holder (4) and then slide the universal
joint to the rear.
(When reassembling)
• Apply grease to the splines of the propeller shaft and universal
joint.
• When inserting the spring pins (3), face their splits in the
direction parallel to the universal joint as shown in the figure.
• Arrange the position of the clamp (2) at side as shown in figure.
• Replace the spring pins (3) with new ones.
(1) Universal Joint Cover
(2) Clamp
Separating the Engine from the Clutch Housing
1. Place the disassembling jack under the engine and center
frame.
2. Remove the engine mounting screws and nut, then separate the
engine from the clutch housing with starter motor.
(When reassembling)
• Apply liquid gasket (Three Bond 1211 or equivalent) to joint face
of the engine and clutch housing.
• Apply liquid gasket (Three Bond 1211 or equivalent) to joint face
of the engine and starter motor.
Clutch housing and engine
mounting screw (M8)
Tightening torque
Clutch housing and engine
mounting screw (M10)
3-S9
TRANSMISSION
(3) Spring Pin
(4) Bearing Holder
9Y1210436ENS0028US0
18 to 21 N·m
1.8 to 2.1 kgf·m
13 to 15 lbf·ft
48 to 21 N·m
4.9 to 5.7 kgf·m
36 to 41 lbf·ft
9Y1210436ENS0029US0
KiSC issued 06, 2012 A