wsm B2420 Workshop Manual page 165

B2420, WSM
Steering Wheel, Meter Panel, Panel Under Cover and Step
1. Remove the steering wheel cap.
2. Remove the steering wheel mounting nut and remove the
steering wheel (2) with a steering wheel pillar (Code No.
07916-51090).
3. Tap out the spring pin (6) and remove the hand accelerator
lever (1).
4. Open the meter panel (3).
5. Disconnect the meter panel connector, combination switch
connector, hazard switch connector and hour meter cable. Then
remove the meter panel (3).
6. Disconnect the main switch connector and remove the panel
under cover (4).
7. Remove the rubber mat (5).
8. Remove the steps.
Steering wheel mounting
Tightening torque
nut
(1) Accelerator Lever
(2) Steering Wheel
(3) Meter Panel
Delivery Pipe, Suction Pipe and Others
1. Remove the brake rod R.H. (1) and parking brake rod (5).
2. Remove the pipe clamp and disconnect the 3-point hitch
delivery pipe (2) from the hydraulic cylinder.
3. Disconnect the suction pipe (3) at the transmission case side.
Joint bolt (3-point hitch
Tightening torque
delivery pipe)
(1) Brake Rod, R.H.
(2) 3-point Hitch Delivery Pipe
(3) Suction Pipe
Brake Rod and Parking Brake
1. Remove the brake rod L.H. (4) and parking brake rod (5).
2. Remove the parking brake lever rod (2).
3. Remove the external snap ring, then remove the parking brake
assembly (1).
4. Remove the joint pin (6), then remove the parking brake arm (3).
5. Remove the parking brake shaft.
(1) Parking Brake Assembly
(2) Parking Brake Lever Rod
(3) Parking Brake Arm
3-S12
TRANSMISSION
30 to 49 N·m
3.0 to 5.0 kgf·m
22 to 36 lbf·ft
(4) Panel Under Cover
(5) Rubber Mat
(6) Spring Pin
9Y1210436TRS0010US0
50 to 60 N·m
5.1 to 6.1 kgf·m
37 to 44 lbf·ft
(4) Parking Brake Shaft
(5) Parking Brake Rod
9Y1210436TRS0011US0
(4) Brake Rod L.H.
(5) Parking Brake Rod
(6) Joint Pin
9Y1210436TRS0012US0
KiSC issued 06, 2012 A