Disassembling Rear Axle Case - wsm B2420 Workshop Manual

B2420, WSM

(3) Disassembling Rear Axle Case

Differential Lock Shift Fork, Differential Lock Clutch (Right
Side Only), 57T Gear and Rear Axle
1. Remove the spring (1).
2. Draw out the differential lock shift fork (2) and differential lock
clutch (3).
3. Remove the external snap ring (6) and remove the bearing (5).
4. Draw out the 57T gear (4) from the rear axle (7).
5. Tap out the rear axle (7) to the outside of the rear axle case.
(1) Spring
(2) Differential Lock Shift Fork
(3) Differential Lock Clutch
(4) 57T Gear
Brake Assembly
1. Remove the internal snap ring (4).
2. Remove the brake shaft (1) with brake discs.
(When reassembling)
• When installing the internal snap ring (4) to rear axle case (3) as
shown in the figure.
• When installing the bearing holder (2) to the rear axle case (3),
do not forget to install the straight pin (5).
(1) Brake Shaft
(2) Bearing Holder
(3) Rear Axle Case
Brake Discs and Friction Plates
1. Remove the external snap ring (1), and remove the brake discs
and friction plates.
(Reference)
• 3 brake discs and 2 friction plates.
2. Remove the cam plate and balls.
3. Remove the external snap ring and pull out the brake cam lever.
(When reassembling)
• Install the brake discs with their holes (2) deviation at less than
1/3 of the total hole area.
(1) External Snap Ring
5-S8
BRAKES
(5) Bearing
(6) External Snap Ring
(7) Rear Axle
9Y1210436RAS0005US0
(4) Internal Snap Ring
(5) Straight Pin
9Y1210436BRS0006US0
(2) Hole
9Y1210436BRS0007US0
KiSC issued 06, 2012 A