Hook-Up To Gas Supply - DCS RDS-305 Installation Manual

ELECTRICAL / GAS CONNECTIONS
STEP 5: (CONTINUED)
RECOMMENDED GROUNDING METHOD
This appihnce is factory equipped with a power supply cord with a four-prong grounding plug. it
must be pHugged into a mating grounding, type receptacHe, connected to a correctHy poHarized 120/240
voHt circuit. Hf the circuit does not have a grounding type receptacHe, it is the responsibility and
obligation of the installer to have the existing receptacle changed to a properly grounded and
polarized receptacle in accordance with ail appikabie local codes and ordinances by a qualified
eiectrkian, in the absence of local codes and ordinances, the receptacle replacement shall be in
accordance with the National Eiectrkal Code.
THE FOURTH PRONG (ROUND GROUNDING PIN) SHOULD NOT, UNDER ANY
CIRCUMSTANCES, BE CUT OR REMOVED,
GAS REQUIREMENTS
Verify the type of gas suppHied to the Hocation, The range is shipped from the factory set up and
adjusted for naturaH gas or L,R gas as specified by the customer order, If the range is not compatible
with gas supply, return it to the dealer,
NATURAL GAS
Con nection: 1/2" N,RT, Minimum 5/8" dia, flex line, Pressure: 6"to 14"W.C.
LP GAS
Con nection: 1/2" N,RT, Minimum 5/8 dia, flex line, Pressure: 11"to 14" W,C,
A regulator is required at the LP source to provide a maximum of 14"W.C.to the range regulator.
HOOK-UP TO GAS SUPPLY
STEP 6:
HOOK-UP
A manual valve must be installed external to the appliance, in an accessible location from the front for
the purpose of shutting off the gas supply. The supply line must not protrude beyond the back of the
unit. Make sure the gas supply is turned offat the wall valve before connecting the appliance.
The gas suppJy connections shouJd be made by a quaJified technician and in accordance with [oca[
codes or ordinances. In the absence of a local code, the installation must conform to the National Fuel
Gas Code ANSI 223.1-1988, latest edition.
14