Planning The Installation; Unpacking And Handling - DCS RDS-305 Installation Manual
The rds
Hide thumbs
Also See for RDS-305:
- Use and care manual (74 pages) ,
- Installation manual (30 pages) ,
- Use and care manual (37 pages)
Table of Contents
Advertisement
PLANNING THE INSTALLATION
RECOMMENDED INSTALLATION INSTRUCTION
Install components
in the following
order:
A) Vent Hood
B} Backguard System
C) Range
1) Locate and [eve[ range according
to range installation
instructions.
2} Measure distance from floor to top of isHand trim on range, adding
1/8"for
backguard
cHearance.
3) Transfer this measurement
to the waHL This wHHmark the bottom
of your backguard.
4) From this Hine measure 28" up waHHto mark top of 30" backguard.
This is the minimum
height
that the bottom
of your vent hood can be instaHHed.
6} FoHHow vent hood manufacturer's
instaHHation instructions
to instaHHvent hood.
7} FoHHowbackguard
instaHHation instructions
to instaHHbackguard.
8) Connect gas and eHectric connections
and snide range into position.
UNPACKING AND HANDLING
STEP 1 :
MOVING AND PLACING THE RANGE
The ranges
have shipping
weights
varying
from
4201bs. to 6301bs less approx. 501bs. after removal of
packing
material.
It is recommended
that
the
door(s), grates, front kick panel, and drip pan (below
knobs) be removed
to facilitate
handling.
This will
reduce the weight for ease of handling.
Fig. I
Kick Panel
Advertisement
Table of Contents
