Backguard Installation; Electrical / Gas Connections - DCS RDS-305 Installation Manual

BACKGUARD iNSTALLATiON
STEP 4:
BACKGUARD KITS:
The backguard is located as shown in Fig.
12. Secure the backguard to the wall[
behind the range. Specific instructions for
instaHHation of the full[ backguard or How
backguard can be found packaged
with the backguard. See ako page 5,
"Planning The Installation" section.
A backguard must be instaHHedwhen there
is Hess than a 12" cHearance between
combustibHes and the back of the range
(above the cooking surface). See fig. 11.
wd[ Mount
Full Backguard
(Model #'s BGS 3030,
BGS 3036, BGS 3048)
Wall Mount
Low Backguard
(Model #'s BGS-1230,
BGS4 236, BGSH 248)
ELECTRICAL / GAS CONNECTIONS
STEP 5:
ELECTRICAL CONNECTIONS
RDS-36 & 48 models
AHways disconnect eHectdc suppHy cord from the
wall outlier or service disconnect before servicing
this appliance, Observe a[[ governing codes and
ordinances when grounding, in absence of
which, observe National Electrical Code ANSI /
NFPA No. 70-1990. The electrical supply must be
a 120/240 volt, 3 wire (plus ground) 60 Hz single
phase, 50 AMP circuit. The power receptacle
must be a NEMA 14-50 device to accept the four
prong plug supplied with the unit.The receptacle
should be located within the area shown in fig.&
page 10.
_--Electrical Supply
NEMA 14-50
Receptacle
RDS-305 MODEL FO. 13
The electrical supply must be a 120/240 volt, 3
wire (plus ground), 60 Hz, 30 AMP circuit. The power receptacle must be a NEMA 14-50 device to
accept the four prong plug supplied with the unit.
The receptacle should be located within the area shown
in fig. 9, page 1 1.
13