Test And Adjustments - DCS RDS-305 Installation Manual

TEST AND ADJUSTMENTS
STEP 7:
WARNING :
For Warranty coverage, DCS requires that burner adjustments be made by a
qualified technician at the time of installation. Extreme care shouM be u s e d
when adjustments are made after instaflation. Improper or lack of
adjustments will void your warranty°
Note: No air shutter adjustment is possible on the top burners. This adjustment section
applies to the griddle end grill burners.
Check for the proper burner flame character-
istics and adjust air shutters if necessary (fig.
15). Each valve and air shutter is individually
tested and adjusted prior to shipment.
Normal[}, adjustment is not required, however,
vibration during transit, gas conversion or
variations in the local gas supply may make
minor adjustments necessary. Burner flames
should be blue and stable with no yellow tips,
excessive noise or lifting of the flame from the
burner. If any of these conditions exist, check
that the air shutter or burner ports are not
Mocked. ffthis condition persists, adjust the air
shutter as required, ff the flame is too yellow,
indicating insufficient air, adjust the shutter
counterclockwise to increase air inlet, ff the
flame is noisy or tends to lift away from the
burner, indicating too much air, turn the shutter
clockwise to reduce air. The gddd[e flames
should be 1-1/2" to 2". The grill burner flames
should be 3/8"to 5/8"(fig. 16).
ffthe top burner does not ignite, check the
spark igniter by listening for a clicking sound.
ffyou do not hear the igniter dick, turn offthe
burner. Check for a tripped circuit breaker,
blown fuse, or poor wire connection to the
igniter.
FO. 1S
Typical Section of Proper Flame
Griddle Grill
3,84
F/go 16
TO CLEAN EXTERIOR SURFACES
The stainless steel surfaces may be cleaned by wiping with a damp soapy cloth. Any mild glass cleaner
wi[[ remove fingerprints and smears. Do not use steel woo[ as it wi[[ scratch this surface. Small
scratches may be removed by lightly sanding, with the grain, using 120 grit paper.
16