Set The Station Address - Printronix p4280 Setup Gudie

Set the Station Address

If you have a twinax interface, use the following steps to set the station
address in order to avoid address conflicts with other devices which may be
on the same cable.
If you have a coax interface, skip this section and continue with "Connect the
Interface Cable."
Step
1.
Check your system's addresses and write them down. Open the printer cover.
2.
Press: START
STOP
3.
PREV
4.
5.
6.
7.
2–14
Press
PGM ALT
+
UNTIL
OR UNTIL
Result
OFF LINE
ENTER SWITCH
NOT LOCKED
CONFIGURATION
MENU
SIGNAL VOLUME
SELECTION
STATION ADDRESS
SELECTION
STATION
ADDRESS 000
Notes
The unlocked state al-
lows you to make con-
figuration changes.
You MUST press PREV.
Setting Up the Printer